1st gen front custom springs

[miket]

1st gen custom front springs 350 psi - height was 320mm from centre of hub to underside of guard, 1 inch or so lower than stock on s3 rx7
[b]Item Condition:good but has rub marks where tyre was rubbing ( using incorrect offset rims )using + 43mm offset rims not +38mm as it is std.
[b]Price and price conditions:$90
[b]Extra Info: http://www.ausrotary.biz/images/smilies/icon_neutral.gif
[b]Pictures:attached
[b]Contact Details:PM or mob : 0433 094 394
[b]Location:Adelaide , S.A

[miket]

:rapide:.................

[brooke]

How would these go in a daily driver setup, with pedders low at the back, and kyb gas shocks all round. After a comfy, yet sporty ride. Good all rounder

[miket]

They will lean to the firmer side but still drivable .....i drove it both on the street and track.
Shocks must be new or near new as if they are not the shocks will deminish quicker than normal...

Michael...

[brooke]

Will leave it at that then, gonna end up going standard height springs after todays drive :)

Thanks anyhow